23-01-2017, 00:12
There is another way too:
Configure the Pro2 PLUS RX software to connect to a WiFi network which allows any connection.
Upload the software, then, with the VP1 switch still in program position, open your serial monitor, the unit will reboot.
After a successful connection, you will see the local IP and the MAC address.
Configure the Pro2 PLUS RX software to connect to a WiFi network which allows any connection.
Upload the software, then, with the VP1 switch still in program position, open your serial monitor, the unit will reboot.
After a successful connection, you will see the local IP and the MAC address.

