[Barrow4491]

Nice work Wizza!

I take the opportunity to write a little note, specially for those that chose to use the BME280 sensor (not the BMP280).

As the BME280 will also act as your inside Temperature / Humidity sensor, I think its better install it outside of the Pro2 PLUS box, and connect it to the RX board using some wires.

Werk,
Thanks for the note. It made me think about my Rx which has a module purchased on EBay (Item No 191736124959) labelled BME/BMP280, combined temp/press/humidity, which I have installed inside the Rx case but will move it outside the case ASAP.
It looks identical to the one Wizza has pictured in his post.
In the Config_Rx.h file I selected option 0 (BME280) for inside Temp/Pressure and Barometric pressure and it works OK
Regards
Jim