28-11-2014, 12:04
Don't know why I haven't noticed this before but the 3.0 Parts list mentions VP1 and VP2 but they are not marked on the board.
I assume they are the 2 two holes to the left of the SWT in the photo above. I can see VP2 is not in use as in the Parts list so I assume the one next to SWT is VP1 and it is the On/OFF switch.
As I am going to always have my RX board ON do I need this switch?
I assume they are the 2 two holes to the left of the SWT in the photo above. I can see VP2 is not in use as in the Parts list so I assume the one next to SWT is VP1 and it is the On/OFF switch.
As I am going to always have my RX board ON do I need this switch?