16-11-2016, 02:25
(14-11-2016, 12:04)MikeM Wrote: When I ordered the temp/hum sensors for my WeatherDuino system I thought I was being clever and and ordered 3x SHT31 sensors so that all the temp sensors is of the same type.
One for outside temp on TX unit, one for inside temp on RX unit and one for the WD unit.
Yesterday I was going through the software configuration of the TX, RX and WD. Their is only an option on the TX unit for the SHT31 sensor.
I take it I'll have to order something like HTU21 sensors for the RX and WD units which is supported by the software configuration. Or might their be a work around that would allow me to use the SHT31 sensor I already bought?
Hi MikeM
The type of temp / hum sensors supported by the RX and WD units are also specified on the respective parts list.
The only work around is adding support for the SHT31 on the RX and WD software. It's possible that at some point in the future I will do it, but I can't say when.
For use inside the house, the HTU21D is a really good and precise sensor.
Regards