16-10-2016, 11:49
(16-10-2016, 08:29)Palmyweather Wrote: Great news, Barrow4491 is now all set up with his custom display. After seeing the code that was being used, there was one little error. on this line, the "d" in display was a lower case, when it should have been a capital "D".
#if Wind_Display_Unit == 3
I hope by showing this custom LCD display code will get others thinking about ways they can use this fanatic software and customise it to their requirements.
Matt,
I would like to express my sincere thanks to you for the assistance freely given both on the forum and by PM.
This sort of guidance is what assists a community with common interest, but not fully competent in all aspects of the project, learn something every day and I look forward to further enhancements to what is a fantastic project.(ie the possibility of air quality monitoring for example)
Jim
Regards
Jim