12-09-2016, 06:34
Hi,
I have been chasing down a problem where my system suddenly stops updating the RX data even though the Rx led is flashing regularly. It also takes an age sometimes to initialize sitting with just 2 "ones" for extended periods of time (up to 20 minutes)before eventually coming on line.
I assumed it was the Tx unit so I swapped out the Tx module, next the nano and finally the antenna, all with no effect.
I have no idea if the Led's on the nano have any meaning but in the TX unit only the power led is lit
Is there any definitive way of ensuring the unit is actually transmitting.
JIm
I have been chasing down a problem where my system suddenly stops updating the RX data even though the Rx led is flashing regularly. It also takes an age sometimes to initialize sitting with just 2 "ones" for extended periods of time (up to 20 minutes)before eventually coming on line.
I assumed it was the Tx unit so I swapped out the Tx module, next the nano and finally the antenna, all with no effect.
I have no idea if the Led's on the nano have any meaning but in the TX unit only the power led is lit
Is there any definitive way of ensuring the unit is actually transmitting.
JIm