11-09-2016, 15:19
Hi Jim,
You are right! The Station ID must have the same value on the Config_RX.h and Config.TX.h files. It can be any value between 0x00 and 0xFF.
Also, the Relay_ID should be different from Station_ID.
To avoid any confusion, I have edited the value on the examples above.
Thank you.
You are right! The Station ID must have the same value on the Config_RX.h and Config.TX.h files. It can be any value between 0x00 and 0xFF.
Also, the Relay_ID should be different from Station_ID.
To avoid any confusion, I have edited the value on the examples above.
Thank you.