[zitoune]

Close up on the rain gauge and the radiation shield. Note I have placed there the solar and UV sensor, but this is not their definitive place.




Close up on the two Inspeed wind sensors:



The TX v2.5 on the top left, the new TX v3.12 on the top right and the Leaf/Soil Interface. I have mounted the FD10036 on the TX v2.5 with no antenna, just a wire of the same length as the standard RF antenna.
All connections with CAT5 cable to the bottom of the enclosure.



One of the VH400:




And of course the upgraded RX v5.02 with its Raspberry pi3:



You can see all the data here.

I have made a quick video (looks a bit squeezed though):here

That's it for now! Next steps:
- Add two LWS sensors
- Build and integrate the 2.5PPM sensor to the WeatherDuino Pro2

Regards,
Zitoune