22-08-2016, 13:13
Do you have the tx unit running? IIRC it won't finish booting if it doesn't receive the necessary packets.
You can enable the debug routine which should allow it to boot at least.
This has been covered before on this forum, but it may take a bit of digging around to find the post(s). Try a search on "debug" (Until Werk chimes in at least
).
You can enable the debug routine which should allow it to boot at least.
This has been covered before on this forum, but it may take a bit of digging around to find the post(s). Try a search on "debug" (Until Werk chimes in at least
).