[zitoune]

I realised my RX v4 board has a KDX10036 to relay the data. So, instead of waiting for my transmitter modules to arrive by post, I actually build the new RX v5.02 (I had all the spare parts already, only re-used the HF receiver module) and used this HF emitter to replace the one of my new TX v3.12 and ... immediately it was a success! I can now receive all data on my RX Thanks for your help.

I reconnected my Raspberry pi3 to CumulusMX, and everything is back to normal with this all new setup!

I'll post some pictures soon of my upgraded system.

Regards.