09-08-2016, 10:23
I have setup the TX to send only one type of data at the time:
- with only the temp/humidity, I see the LED blinking every 25 sec or so,
- with only the wind sensor, the blinking happens every 5 sec or so,
- with only the rain, it's every 30 sec.
So looks like we are good wit the TX board.
When running in test mode, the RX LED is constantly off; while in standard mode, it's always ON (supposed to be blinking, right? i dont remember).
I can see the TX LED of the RX board blinking as well.
I just replaced the receiver module on my RX, but still cannot see anything
Once I was running in standard mode and go 110 during initialisation, since then, nothing more than 000.
It looks like the amplitude of the signal measured on the DATA pin of the receiver increases when I connect the antenna; makes sense though.
Not sure what else I can do - maybe change the TX transmitter to be a KDX-10036 as you specified (now it's the previous model)? I have ordered one.
Regards.
- with only the temp/humidity, I see the LED blinking every 25 sec or so,
- with only the wind sensor, the blinking happens every 5 sec or so,
- with only the rain, it's every 30 sec.
So looks like we are good wit the TX board.
When running in test mode, the RX LED is constantly off; while in standard mode, it's always ON (supposed to be blinking, right? i dont remember).
I can see the TX LED of the RX board blinking as well.
(09-08-2016, 02:45)Werk_AG Wrote: Anyway, replacing the transmitter module is possibly the simpler procedure.
Please keep me informed.
I just replaced the receiver module on my RX, but still cannot see anything
Once I was running in standard mode and go 110 during initialisation, since then, nothing more than 000.
It looks like the amplitude of the signal measured on the DATA pin of the receiver increases when I connect the antenna; makes sense though.
Not sure what else I can do - maybe change the TX transmitter to be a KDX-10036 as you specified (now it's the previous model)? I have ordered one.
Regards.