05-06-2016, 07:40
(This post was last modified: 05-06-2016, 07:40 by spudstrawb.)
I found my crimping tool, so I cut the RJ12 plug back off again and put a new one on. Wind direction and speed are now working. I just need to get the rain sensor sorted now and then I can progress to boxing it all up and installing sensors, sorting RPi etc. Slowly getting there.
I'm not planning to have any UV or solar radiation sensors at this stage. We don't have town water where we are, so we rely on catching rainwater from the roof and storing it in tanks. I currently have a tank water level device which is connected to my main PC via serial cable (15m) and a USB to serial adaptor. Is there any way that I can get that to report onto the WD display in place of the Srad and UV rows? It would be great if I could.
I'm not planning to have any UV or solar radiation sensors at this stage. We don't have town water where we are, so we rely on catching rainwater from the roof and storing it in tanks. I currently have a tank water level device which is connected to my main PC via serial cable (15m) and a USB to serial adaptor. Is there any way that I can get that to report onto the WD display in place of the Srad and UV rows? It would be great if I could.