[Wizza]

Round two of Raspbian loaded and running. Didn't take too long, second time round. Have SSH working ok and using my trusting old PuTTY client that I use for Cisco programming. All good there. Loaded the VNC again, per the many instructions around the net, and still the same issue. Did some more testing, and the error relating to an authentication agent already present only shows if you have the xwindows GUI running on the Pi (on the HDMI output). If I change raspi-config to not load the xwindows GUI on boot, then there is no issue on the VNC client. Was going to run headless anyway, so will probably just do this and move on. This gives me xwindows via VNC and SSH shell so all good for admin and setup tasks down the track Now to work out how to load Mono and CumulusMX. I'll head off and have at look at the URL referred to above. Thanks guys...

Cheers for now.
Mark R

---

Sandaysoft says no installer, just unzip and copy into a folder. Shall I pull the SD card from the PI, and do the copy over on a PC..??? Dont know what the file system is, or if a PC will even read it..??? Is there a recommendation for where and what to call the new folder..??? Just "Cumulus" foldername, off the Pi home folder / directory..??? Is it going to be one of these things down the track, where someone says, oh you should have called the folder this, or you should have put it there..???? All new... I'll keep reading..

Mark R