18-10-2014, 12:58
Hello,
I think that after a windows update, I can't connect my receiver. When I start EasyWeather RS232 Logger, the programme doesn't find a COM port, when I try to connect the receiver with the Arduino IDE, the port is greyed and I can choice a port.
When I look the device manager I have in "Other devices" : FT232R USB UART with yellow triangle and "!" inside, I have installed CDM20824_Setup.exe, right click on the FT232 and look at properties, there is no driver installed. I try also the driver CDM v2.12.00 WHQL Certified, but same.
I think that the Arduino Nano of the receiver works with a FTDI FT232R driver, because there are now Arduino Nano with CH340G chip. I have such 2 Arduino Nano and when I connect them, I have the COM port 11 (USB-SERIAL CH340). What do I wrong?
I think that after a windows update, I can't connect my receiver. When I start EasyWeather RS232 Logger, the programme doesn't find a COM port, when I try to connect the receiver with the Arduino IDE, the port is greyed and I can choice a port.
When I look the device manager I have in "Other devices" : FT232R USB UART with yellow triangle and "!" inside, I have installed CDM20824_Setup.exe, right click on the FT232 and look at properties, there is no driver installed. I try also the driver CDM v2.12.00 WHQL Certified, but same.
I think that the Arduino Nano of the receiver works with a FTDI FT232R driver, because there are now Arduino Nano with CH340G chip. I have such 2 Arduino Nano and when I connect them, I have the COM port 11 (USB-SERIAL CH340). What do I wrong?