[Wizza]

Hi JT, I measured the collector this afternoon, and it is 200mm across. From yesterday's testing I measure that it was about 6.5ml to tip the bucket once. I re-ran the calibration test this afternoon, based on the 653mL test outlined above and I registered 18.2mL of rain fall on the WD. I confirmed the gauge was level. As you mentioned, this gauge looks pretty calibrated and set with all the red locktite, so I was pretty loathed to start adjusting it. But, if it isn't quite right, I guess I need to do something. Do you think the WD software just isnt matched to the gauge..?? Can I put a decimal place in the TX config for the rain gauge, and make it 2.2 or something like that (instead of 2.0 or 3.0)..??? Or do you think I should crack the locktite and start mechanically adjusting the stop screws in the gauge..???
Cheers for now...
Mark R