26-03-2016, 02:34
Great to see the project is alive and well and new software updates are being published. Congratulations. My station has been running for many months now with very few problems.
I have just started to upgrade to v2.0 b011 and found the Tx upgrade went well and I am receiving data on my Rx v4.03 board with a TFT display running Rx 013 b015. (Getting no outside temp readings and a crazy rainfall reading of many mm of rain but not too worried until I get the Rx board software upgraded)
I do not have an EPROM installed. Can I continue to use my TFT SPI display or must I change to an LCD I2C? I have disabled the logger in the config file but not getting anything on the TFT display with the new Rx v2.0 b011.
Thanks Dave
I have just started to upgrade to v2.0 b011 and found the Tx upgrade went well and I am receiving data on my Rx v4.03 board with a TFT display running Rx 013 b015. (Getting no outside temp readings and a crazy rainfall reading of many mm of rain but not too worried until I get the Rx board software upgraded)
I do not have an EPROM installed. Can I continue to use my TFT SPI display or must I change to an LCD I2C? I have disabled the logger in the config file but not getting anything on the TFT display with the new Rx v2.0 b011.
Thanks Dave