19-02-2016, 06:28
(19-02-2016, 04:44)grunge Wrote: ...it has been sitting for the last few hours with "Wait for Auto-Reboot".
I'll troll through the forums :-)
Just read some posts above...
http://www.meteocercal.info/forum/Thread...22#pid3422
Quote:At least activate ID0, ID2 and ID3, and the RX unit will happily pass the initialization phase, without having to run it in test mode.
If after a power up the RX unit stay more than a few minutes in "Wait for Auto-Reboot" or "Don't connect weather software yet" the most probable cause is because it is not receiving Temp / Hum, Wind and rain data from the TX unit.
Even if you haven't those sensors connected to the TX unit, at least on the TX software enable the sending for those type of data.
When using just one TX unit, ID0, ID2 and ID3 must not be commented.