Quote:Maybe it is. Try to run the WeatherDuino Pro2 RX software with your hardware. If you get data from your Auriol wind and rain sensors it works. Before upload to Arduino, don't forget to configure it to use Auriol wind and rain instruments.
For testing purposes I also use one AUREL receiver module. It is very good, perhaps one of the best.
I tested the latest version with source available for auriolduino and it works perfectly (with some adjustments due to the absence of some parts). I'm ordering the missing parts (lcd, ds3231, DHT22) to complete the receiver.
I then picked up in my pyranometer and saw that uses a photodiode as a sensor. I saw the link (http://www.instesre.org/construction/pyr...ometer.htm)
and, having already the photodiode and the houses with the diffuser in teflon, I would like to achieve something similar. Do you think I can amplify the signal with the same system indicated for the solar sensor on the forum.