Quote:I'd say yes. Are the sensors from a fine offset station?No. Is for a weather station sold only un Italy (De Agostini), but use the auriol protocol. I use a sketch wrote by cillo273 (a man that leave in sicily) from auriows forum.
Welcome aboard by the way.
Originally the weather station have 4 sensors. Wind, rain, T/H and a pyranomether. The last one is dead (two times).
I am very interested in the sensor of the solar radiation and uv to get back all the weather data that interest me .
In the photo an example of de agostini weather station[img]
Quote:Hi loriz71, welcome
My reply is based on suposing that your 3 external sensor are from a Auriol weather station. The WeatherDuino Pro2 RX software / hardware, is able to receive data from your Auriol wind and rain sensors but not data from Temperature / Humidity sensor. This is because the Temp/Hum data from Auriol weather stations are not very reliable. You must build a Radiation Shield and install inside it a SHT1x (recommended) or a DHT22 sensor.
If I understand correctly I should build two weatherduino pro 2 tx ( one for T / H and one for solar UV radiation ) . For the sunscreen I could reuse what I already have ( daytime ventilated).
Is possible reuse my actual arduino hardware for the receiver (arduino 2009 plus bmp085 and FM Super-het Receiver 434.15 from AUREL)?