19-09-2014, 12:14
(19-09-2014, 08:04)loriz71 Wrote: Hi
I'm a newbye and i have only same soldering experience.
I have 3 external units (wind,rain guage and Temperature/humidity) that works fine with a similar auriolduino board (without SHT).
I can use my actual sensors plus a solar radiation sensor explained in this forum with a weatherduino board.
Thank you for your help
Hi loriz71, welcome
My reply is based on suposing that your 3 external sensor are from a Auriol weather station. The WeatherDuino Pro2 RX software / hardware, is able to receive data from your Auriol wind and rain sensors but not data from Temperature / Humidity sensor. This is because the Temp/Hum data from Auriol weather stations are not very reliable. You must build a Radiation Shield and install inside it a SHT1x (recommended) or a DHT22 sensor.