13-12-2015, 02:09
(12-12-2015, 21:39)Werk_AG Wrote: I think you are trying to avoid put the TX unit in a box outside of the house, ...Not really.
I plan to built two Tx boards for the final implantation so the cables will be shorter
Actually it's just a test and the cables of the rain gauge and the wind sensor are the original ones.
The rain gauge has only a reed switch but as it's a long time i didn't use it i have to check if the connexions are clean.
In the future I'm thinking to buy a Davis wind sensor and perhaps an other rain gauge.
P.S.
I added a 10k resistor around 14H, rainfall was stable until 23:45. Then again the false rain readingss. This may come from moisture, i'll check it tomorrow.