Hi,
Yesterday afternoon i was able to put the TX board outside with sensors connected.
Temperature with 10m cable works fine.
Wind vane (oregon with about 15m cable) is ok.
Wind speed (same cable as wind vane) works but speed is not accurate.
Maybe the form factor isn't well adjusted and the anemometer position isn't at the best position (1.5m above the roof). My actual anemometer is about 3.5m above the roof and give me a wind average 4 time higher and is corresponding nearly what the local met office is giving.
Rain gauge with 8m cable give me aleatory rainfall when it isn't raining.
Since yesterday night at midnight i have 6.1mm of rain that'a about 50 rain gauge clicks !
Is the internal pullup resistor sufficient or should i add an external resistor ?
Thanks to advice me.
P.S. I am glad I found this project and implement it
Link to the test page : http://laurentmey.fr/test/trends.htm
Yesterday afternoon i was able to put the TX board outside with sensors connected.
Temperature with 10m cable works fine.
Wind vane (oregon with about 15m cable) is ok.
Wind speed (same cable as wind vane) works but speed is not accurate.
Maybe the form factor isn't well adjusted and the anemometer position isn't at the best position (1.5m above the roof). My actual anemometer is about 3.5m above the roof and give me a wind average 4 time higher and is corresponding nearly what the local met office is giving.
Rain gauge with 8m cable give me aleatory rainfall when it isn't raining.
Since yesterday night at midnight i have 6.1mm of rain that'a about 50 rain gauge clicks !
Is the internal pullup resistor sufficient or should i add an external resistor ?
Thanks to advice me.
P.S. I am glad I found this project and implement it
Link to the test page : http://laurentmey.fr/test/trends.htm