Hello,
I have observed the same symptoms on my WD unit, but I did not upgrade yet any of my boards to the 1.5v.
That day it's been raining a lot and the RX displayed....19800mm of water!! Obviously it was wrong
so I suspected the length of this field sent to the WD was too long (out of bounds).
Even after rebooting all boards the WD kept rebooting by itself.
One day later, no rain, the behaviour was back to normal. The next day it rained about 13.2mm and it showed it properly.
So I believe something to do with the fact the WD goes haywire if it receive data out of it's storage/display range?
Thanks.
I have observed the same symptoms on my WD unit, but I did not upgrade yet any of my boards to the 1.5v.
That day it's been raining a lot and the RX displayed....19800mm of water!! Obviously it was wrong
so I suspected the length of this field sent to the WD was too long (out of bounds).Even after rebooting all boards the WD kept rebooting by itself.
One day later, no rain, the behaviour was back to normal. The next day it rained about 13.2mm and it showed it properly.
So I believe something to do with the fact the WD goes haywire if it receive data out of it's storage/display range?
Thanks.