10-11-2015, 20:15
Hi, strada916
Surely we will find what is causing the reboots.
Trying to go to backward versions may not be the best way, so I suggest you to upgrade all units to the latest software release. Also remember that different software release numbers are not compatible among them. Maybe is not the case, but anyway never mix units with software v1.4 with others with software v1.5
- After upgrading all the units, power up TX unit, then power up (after configured) RX unit.
- Make sure RX unit starts correctly, and it is receiving data from TX unit.
- Power up WD unit.
When testing, don't keep the units very close to each other, keep at least one meter between them. These things are designed to work several meters apart from each others.
Please report what happens after executing the above procedures.
Notes: Latest RX software requires a fully working TX unit to successfully complete initialization sequence, if you don't have a fully working TX unit, start RX unit in Test Mode.
In all cases, and this is a info for everybody, never try to test a unit that is not fully assembled with all the required parts and sensors connected to it.
Posting config files can help too.
Surely we will find what is causing the reboots.
Trying to go to backward versions may not be the best way, so I suggest you to upgrade all units to the latest software release. Also remember that different software release numbers are not compatible among them. Maybe is not the case, but anyway never mix units with software v1.4 with others with software v1.5
- After upgrading all the units, power up TX unit, then power up (after configured) RX unit.
- Make sure RX unit starts correctly, and it is receiving data from TX unit.
- Power up WD unit.
When testing, don't keep the units very close to each other, keep at least one meter between them. These things are designed to work several meters apart from each others.
Please report what happens after executing the above procedures.
Notes: Latest RX software requires a fully working TX unit to successfully complete initialization sequence, if you don't have a fully working TX unit, start RX unit in Test Mode.
In all cases, and this is a info for everybody, never try to test a unit that is not fully assembled with all the required parts and sensors connected to it.
Posting config files can help too.