07-11-2015, 01:25
(06-11-2015, 22:57)zipidy66 Wrote: Is this the same issue or is it related to the issue talked about in http://www.meteocercal.info/forum/thread-81-page-2.html this thread and an eeprom problem? I was about to follow those instructions until i read this post.
That post is very old, the issue reported above by qldbureau is not related to anything in that post.
(06-11-2015, 22:57)zipidy66 Wrote: I was just investigating this issue myself, Not having much rain lately is probably the reason for not detecting the problem. I Noticed that after about 25mm of rain @ a rate of 30 - 50mm per hour it would all of a sudden show roughly 107mm @ a rate of 8999mm per hour!
The Rainfall rate bug is now corrected. Please download the lastest release.
In fact the bug only appeared after a certain value of Rainfall rate, a wrong variable type was the cause.
(06-11-2015, 22:57)zipidy66 Wrote: I am also getting some weird temperature readings of +288 and -314 degrees. This has only happened since upgrading to TX_v1.5-b008 and RX_v1.5 b004 02/09/2015
Please carefully check the settings for your Temp / Hum sensor in user config options, in both TX and RX software.
If needed create a new topic, and post both files: Config_TX.h and Config_RX.h, also specify the type of outside Temp / Hum sensor you are using.