12-10-2015, 11:51
My Raspberry Pi arrived at the end of last week. I am very happy to say I successfully loaded it with Raspian Wheezy 05/05/2015, performed updates, installed Mono and CumulusMX. I was getting the "cannot connect to station" error at first for some reason I am not sure. After checking and rechecking the connection configuration I powered both the Pi and Rx unit down and rebooted. No problem after that.
It is even updating my Saratoga template and Steel Series Gauges. I managed the complete setup and have never plugged a screen or keyboard into the Pi.
Will now consider my options for rehousing the Rx unit and Pi into a box as seen in another thread. My Pi is sitting bare next to my Rx box and connected by ethernet. I will likely purchase a wifi module.
It is even updating my Saratoga template and Steel Series Gauges. I managed the complete setup and have never plugged a screen or keyboard into the Pi.
Will now consider my options for rehousing the Rx unit and Pi into a box as seen in another thread. My Pi is sitting bare next to my Rx box and connected by ethernet. I will likely purchase a wifi module.