03-09-2015, 00:54
Upgrade from v013 or v1.4 to WeatherDuino Pro2 v1.5
WeatherDuino Pro2 v1.5 is backward compatible with all previously released RX, TX and WD boards, but to use some of the newly supported wind instruments a small modification on TX v2.50 boards is required.
* If you are upgrading from v013 to v1.5, follow the same guidelines written in the post above.
* If you are upgrading from v1.4 to v1.5, just upgrade the software on all units to v1.5 (RX, TX and WD).
Remember: Always check user config options for each software. Default options, often are not suitable for you.
WeatherDuino Pro2 v1.5 is backward compatible with all previously released RX, TX and WD boards, but to use some of the newly supported wind instruments a small modification on TX v2.50 boards is required.
* If you are upgrading from v013 to v1.5, follow the same guidelines written in the post above.
* If you are upgrading from v1.4 to v1.5, just upgrade the software on all units to v1.5 (RX, TX and WD).
Remember: Always check user config options for each software. Default options, often are not suitable for you.