24-08-2015, 13:38
I have my RX board assembled and running using a 2004 LCD. I see that some units (such as temperature and windspeed) are configurable in Config_RX.h, but there are some other formats/units that I'd like to set to match US standard, and I don't see a way to do that:
No doubt I could change any or all of these by messing with the code, but I'm thinking it's much more likely they're configurable somewhere, and I just haven't found where yet.
- Date - it's showing dd-mm-yyyy, while I'd like to use mm/dd/yyyy or even dd-mmm-yy
- Time - I'm fine with 24-hour time, but 12-hour seems like a good option as well
- Rain - inches instead of mm (and, on that note, is mm/m^2 really correct? 1mm of rain is the same whether it's on a square cm or a square km, right?)
- Atmospheric pressure - inHg vs. mBar
- TX case temp - deg F vs. deg C
No doubt I could change any or all of these by messing with the code, but I'm thinking it's much more likely they're configurable somewhere, and I just haven't found where yet.