[uncle_bob]

I promised Werk some pictures of my setup, so I thought I'd share them here.

Here is a mount I made out of an old machine. I'm going to redo this as it's still a bit flimsy.



Here's another view.



Here's is the DHT22 being mounted inside the "Stevenson Screen". I use this as iron roof creates a lot of extra heat, so this sucks the cooler air from down lower.



Here's the fan that sucks from the top of the 90mm pipe.



The WeatherDuino TX unit is mounted in this old nail container



A little further back.

---

Oh, and while I was doing this fiddling about, I noticed the cups missing off my anemometer again
I found them on the ground close to where I had the anemometer leaning. When I pushed them back on, they were quite a loose fit. I've now used a small amount of silicon to "glue" them back on.