29-07-2015, 01:30
I tried the updated sketch, which compiled and uploaded, I then used the serial monitor, but when the vane was turned, the wind direction did not change and correspond to the new position. As said in the first post, when just using the May24 sketch it works perfectly.
I have found a local group which meets weekly, where some off the members have done some programming and they seem to be of the opinion, that there may be a problem due to interrupts (ie not enough of them ) could this be so ?
It is so frustrating, I feel that I am close to getting this mod working but due to my lack of programming knowledge it will take a lot longer, So if any body can help, then it will be appreciated.
Caniera has helped a lot, and I thank him for that, but he is busy with the further development of the weatherduino system.
Regards
tyntop
I have found a local group which meets weekly, where some off the members have done some programming and they seem to be of the opinion, that there may be a problem due to interrupts (ie not enough of them ) could this be so ?
It is so frustrating, I feel that I am close to getting this mod working but due to my lack of programming knowledge it will take a lot longer, So if any body can help, then it will be appreciated.
Caniera has helped a lot, and I thank him for that, but he is busy with the further development of the weatherduino system.
Regards
tyntop