It has been running for more than 24 hours since the last freeze. The last lock up happened just after I switched on my wifi enabled printer that sits next to the Rx box. Interference, or merely a co-incidence I cannot say since I repeat the procedure this morning with no affect.
This is a major improvement as there was a time I could not use the external power port. I am ordering a ferrite usb cable and powered hub. There is no urgency so I can wait.
Update: I already have a powered hub so have just set it up through that. Decided to power everything down and start again. I did get two freezes after setting everything back up, but now running again. Will see if anymore happen whilst waiting for the new cable.
This is a major improvement as there was a time I could not use the external power port. I am ordering a ferrite usb cable and powered hub. There is no urgency so I can wait.
Update: I already have a powered hub so have just set it up through that. Decided to power everything down and start again. I did get two freezes after setting everything back up, but now running again. Will see if anymore happen whilst waiting for the new cable.

