I did have the resistors installed but removed them but made no difference. My logger chip was also purchased from RS but I believe it is working as it should be. When I am connected to my computer receiver is being updated (usually). When I start Cumulus the logger historic data updates fine but the receiver does no longer refresh as the display does not change until I disconnect from Cumulus. As the display does not change while I have Cumulus open I assume that the logger is not being updated. I cannot comment on what happens without 12volts being applied as I am away from home at the moment.
(22-07-2015, 12:48)qldbureau Wrote:(22-07-2015, 12:22)uncle_bob Wrote: Do you guys have R5 an R6 installed by chance?
If so remove them.
No never installed in mine.

