02-07-2015, 06:42
(03-03-2015, 22:14)garybb1 Wrote:(22-02-2015, 20:27)Werk_AG Wrote: Fell free to create the new thread .
Hi
Would it be possible to use a wind sensor such as the WSD1 from Environmental Measurements Ltd
This uses a continuously rotating potentiometer which could be connected as a voltage divider circuit.
http://www.emltd.net/products/wind/wind-...on-sensors
Thanks
(02-07-2015, 00:43)Werk_AG Wrote: Yeah, it looks good!No, it has an aircraft type plug going into anemometer, and bare wires at the weatherduino end. However not too difficult to work a pinout that will go into weatherduino. Large wire gauge on original wiring loom, too big for an RJ11.
As the datasheet don't have any info about the output pinout, could you please try to find it?
What type of connector it uses? RJ11?

