Newbie from Tassie

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Newbie from Tassie

werk_ag
Development Team

Posts: 5.411
Threads: 336
Joined: Apr 2014
Weather Station: WeatherDuino 4Pro
Country: Portugal

Portugal

#6

11-06-2015, 17:12

(11-06-2015, 16:45)AllyCat Wrote: From a photo we can only guess if the "output signal" is a varying voltage (analogue signal) or perhaps some form of data protocol (e.g. a serial data interface such as "RS232"). Do you have any electronics equipment and/or knowledge to "Reverse Engineer" that board? If so I may be able to offer a few hints.

Just guessing but I bet in an analog output, maybe not very different from the "regular" Fine Offset ones.

Find

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Newbie from Tassie - by nparnold - 11-06-2015, 12:44

RE: Newbie from Tassie - by Stuarts - 11-06-2015, 12:50

RE: Newbie from Tassie - by nparnold - 11-06-2015, 13:11

RE: Newbie from Tassie - by AllyCat - 11-06-2015, 16:45

RE: Newbie from Tassie - by werk_ag - 11-06-2015, 17:12

RE: Newbie from Tassie - by werk_ag - 11-06-2015, 16:59

RE: Newbie from Tassie - by AllyCat - 12-06-2015, 00:01

RE: Newbie from Tassie - by nparnold - 12-06-2015, 00:41

RE: Newbie from Tassie - by AllyCat - 12-06-2015, 11:35

RE: Newbie from Tassie - by Shred - 12-06-2015, 04:07

RE: Newbie from Tassie - by werk_ag - 14-06-2015, 03:02

RE: Newbie from Tassie - by Shred - 14-06-2015, 06:14

RE: Newbie from Tassie - by Stuarts - 14-06-2015, 07:49

RE: Newbie from Tassie - by Shred - 15-06-2015, 03:22

RE: Newbie from Tassie - by AllyCat - 15-06-2015, 10:13

RE: Newbie from Tassie - by nparnold - 13-06-2015, 12:16

RE: Newbie from Tassie - by Boots33 - 13-06-2015, 22:28

RE: Newbie from Tassie - by nparnold - 14-06-2015, 01:33

RE: Newbie from Tassie - by Paul_V - 16-06-2015, 11:53

RE: Newbie from Tassie - by Stuarts - 16-06-2015, 14:11

RE: Newbie from Tassie - by nparnold - 17-06-2015, 11:49

View a Printable Version

Users browsing this thread: 1 Guest(s)