11-06-2015, 13:14
I currently have my Weatherduino running on the bench displaying battery voltage for the TX unit.
I know that you are constrained by the Vantage Pro2 protocol but I was wondering if you can see a way to report voltage from multiple TX units.
I'm seriously considering running my RX unit from battery on continuous charge to allow logging during blackouts. It would be nice to be able to monitor all of them.
An additional feature could be to have some audible or visible notification on the RX unit or WD unit to alert the user to the fact that either the internal or remote batteries needed charge or replacement.
Any thoughts guys?
I know that you are constrained by the Vantage Pro2 protocol but I was wondering if you can see a way to report voltage from multiple TX units.
I'm seriously considering running my RX unit from battery on continuous charge to allow logging during blackouts. It would be nice to be able to monitor all of them.
An additional feature could be to have some audible or visible notification on the RX unit or WD unit to alert the user to the fact that either the internal or remote batteries needed charge or replacement.
Any thoughts guys?
Chaos Manor Weather
Mount Evelyn, Australia
http://www.sdsnet.net/weather/cumulus/indexframe.htm
LaCrosse WS-2300, until I have a Weatherduino Pro2 running.