[nparnold]

Hi everybody,

Firstly may i say thankyou for the excellent information on this forum and the articles in Silicon Chip Australia magazines.

I have constructed and currently bench testing/configuring a new weather station, all has gone well, however i noticed my wind direction never changed from ENE. I disassembled the wind vane and had suspicions that the wires were connected the wrong way around as the circuit board was marked GND and VDO, but the GND wire didnt go to the GND of the TX board. So i swapped those and this had me getting all different wind directions but none of them were accurate.

My sensors are Holman WS5029 from Bunnings Australia and i presumed they were fine offset, but looking at the circuit board i am not so sure now. Please see attached wind direction circuit board.

Thanks in advance for your help

Regards
Nathan