Just installed my new Nano featuring an FTDI chip:
While trying to start Weewx 3.1 (not 3.0.1) I end up with exactly the same error messages described in my post #14 above.
Code:
Bus 001 Device 003: ID 0403:6001 Future Technology Devices International, Ltd FT232 USB-Serial (UART) IC
[ 101.916498] usb 1-1: new full-speed USB device number 3 using xhci-hcd
[ 101.941989] usb 1-1: New USB device found, idVendor=0403, idProduct=6001
[ 101.948780] usb 1-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 101.955967] usb 1-1: Product: FT232R USB UART
[ 101.960371] usb 1-1: Manufacturer: FTDI
[ 101.964229] usb 1-1: SerialNumber: XXXXXXXX
[ 102.133952] calling usb_serial_init+0x0/0x167 [usbserial] @ 2966
[ 102.140355] usbcore: registered new interface driver usbserial
[ 102.146221] usbserial: USB Serial Driver core
[ 102.150678] initcall usb_serial_init+0x0/0x167 [usbserial] returned 0 after 1 0233 usecs
[ 102.190443] calling ftdi_init+0x0/0x97 [ftdi_sio] @ 2966
[ 102.195972] USB Serial support registered for FTDI USB Serial Device
[ 102.202644] ftdi_sio 1-1:1.0: FTDI USB Serial Device converter detected
[ 102.209484] usb 1-1: Detected FT232RL
[ 102.213170] usb 1-1: Number of endpoints 2
[ 102.217315] usb 1-1: Endpoint 1 MaxPacketSize 64
[ 102.221977] usb 1-1: Endpoint 2 MaxPacketSize 64
[ 102.226640] usb 1-1: Setting MaxPacketSize 64
[ 102.232640] usb 1-1: FTDI USB Serial Device converter now attached to ttyUSB0
[ 102.240004] usbcore: registered new interface driver ftdi_sio
[ 102.245785] ftdi_sio: v1.6.0:USB FTDI Serial Converters Driver
[ 102.252482] initcall ftdi_init+0x0/0x97 [ftdi_sio] returned 0 after 55124 useWhile trying to start Weewx 3.1 (not 3.0.1) I end up with exactly the same error messages described in my post #14 above.