03-05-2025, 16:10
Has anyone manged to use the pPro2 TX with a professional ultrasonic wind sensor?
I have a Gill Windsonic unit which can out put both serial in both proprietery and NMEA, as well as 0-5Vdc analog data.
Serial I'm guessing is out so probably have to use analog?
The Analog data for direction is output as 0v for 0 degrees, 2.5v for 180 degrees and 5v for 360 degrees.
Speed is 0-5v with the max at 5v being selectable up to 60 M/s
I was wondering if anyone has ever done this and has code for it, if not I'll have to write if myself
Regards
Bob
I have a Gill Windsonic unit which can out put both serial in both proprietery and NMEA, as well as 0-5Vdc analog data.
Serial I'm guessing is out so probably have to use analog?
The Analog data for direction is output as 0v for 0 degrees, 2.5v for 180 degrees and 5v for 360 degrees.
Speed is 0-5v with the max at 5v being selectable up to 60 M/s
I was wondering if anyone has ever done this and has code for it, if not I'll have to write if myself
Regards
Bob