[GerardvanA]

Hi,
I had a look a the windspeed unit last night. I cannot find any markings on it, it is in very good physical condition, black plastic and aluminium mounting pole. No markings on it at all, not on the wind vane nor on the body.
Anyway, the winddirection works perfectly (as shown on the debugging screen), but the windspeed not at all. I went through all the listed options in the config file, but none of them got me a reading.
There was a splice in the connection cable, so I unwrapped that to check it. It looked fine, with no corrosion or obvious faults.
Is there a test I can do (eg put some pulses on the PC board socket pin?) to check if it is the sensor not giving any signal.

Thanks,
Gerard