11-02-2024, 00:45
Hi,
As I mentioned elsewhere, I inherited a system (in pieces) from a friend and am trying to get it going again.
I got the RX unit going (apart from it showing 'Connecting to WiFi' every couple of minutes), and it it displaying the inside temp, humidity and air pressure.
It is not displaying any data from my TX unit. I've got the same Station_ID in both (0xA1), and the TX is sending out data, as I can hear the brusts on 433.8 MHz on my ham-radio receiver (the TX led is also blinking when transmitting). Both units are sitting on the table next to each other.
I can also see a blue dot appearing briefly next to TX0, in the SYSTEM INFO display, however no data displayed there at all.
Debugging show that the TX unit is getting data from the sensors. It also shows "Sending ID2" not sure it that's meaning anything?
The code is well commented, but some sort of a manual would be handy I think.
Any clues to help me get this going?
Thanks,
Gerard
As I mentioned elsewhere, I inherited a system (in pieces) from a friend and am trying to get it going again.
I got the RX unit going (apart from it showing 'Connecting to WiFi' every couple of minutes), and it it displaying the inside temp, humidity and air pressure.
It is not displaying any data from my TX unit. I've got the same Station_ID in both (0xA1), and the TX is sending out data, as I can hear the brusts on 433.8 MHz on my ham-radio receiver (the TX led is also blinking when transmitting). Both units are sitting on the table next to each other.
I can also see a blue dot appearing briefly next to TX0, in the SYSTEM INFO display, however no data displayed there at all.
Debugging show that the TX unit is getting data from the sensors. It also shows "Sending ID2" not sure it that's meaning anything?
The code is well commented, but some sort of a manual would be handy I think.
Any clues to help me get this going?
Thanks,
Gerard