05-02-2024, 20:38
Thanks for that, I can now compile the TX software.
However only after renaming the 'Library' folder to 'library' (first letter case changed)!
Not doing this the IDE created a new (empty) 'library' folder.
I see the SHT2x library is from 2013, while the one I had is from 2023, so there might have been changes in that.
Ok, so I can now move onto the next step, but that may have to wait till the weekend.
Thanks again for the support.
Gerard
However only after renaming the 'Library' folder to 'library' (first letter case changed)!
Not doing this the IDE created a new (empty) 'library' folder.
I see the SHT2x library is from 2013, while the one I had is from 2023, so there might have been changes in that.
Ok, so I can now move onto the next step, but that may have to wait till the weekend.
Thanks again for the support.
Gerard