[Palmyweather]

Thank you for taking the time to test your sensors and for your continued support of the old Pro2 system.

I have tested this again tonight without pin3 connected, but sadly no success. I have attached a screenshot of this in operation.

Attached are also two other screenshots of two different Arduino codes which I have been using to test the the temperature sensors and both codes work without issue. This does use a different DHT code library which was downloaded through the Arduino program.

I have repeated my tests on two different Arduino Nano boards and using two different computers to compile and test the codes, but I get the same results.

I note written inside the sensor under the white cover it says: "ASAIR AM2302 V3.1". Maybe it is a version issue with this sensor?

Any other ideas on what I might be able to do?

Thank you for your help once again.