25-06-2023, 18:11
(25-06-2023, 03:28)Barrow4491 Wrote: ... I suspect my laptop has a port issue as I have never seen Com 8 before ...
This is from your post #5
(10-06-2023, 23:37)Barrow4491 Wrote: Again, after tidying up my library files it now compiles as expected. but i cannot get it to upload; I suspect the module on the board may be faulty. the following message is received.
Sketch uses 924833 bytes (70%) of program storage space. Maximum is 1310720 bytes.
Global variables use 52024 bytes (15%) of dynamic memory, leaving 275656 bytes for local variables. Maximum is 327680 bytes.
esptool.py v4.5.1
Serial port COM8
Connecting......................................
A fatal error occurred: Failed to connect to ESP32: No serial data received.
For troubleshooting steps visit: https://docs.espressif.com/projects/espt...oting.html
Failed uploading: uploading error: exit status 2
That's why I talked about COM8
Hope the new module arrive soon, however first you have to be sure about which port COM the module create when it is connected by USB.
Rgs.
Werk_AG