30-06-2022, 18:03
(30-06-2022, 11:48)Phil23 Wrote: ...
By default the LED's seem of little use in their default config, but they could easily be reconfigured for some more meaningful data.
At this point I was thinking of re-coding them to correspond somewhat with the Print Debug options to the serial monitior
...
Depending on how each user uses the AQM III, the way in which the LEDs are used by default may or may not seem useful.
If you think of an AQM III used in stand alone mode, the way the LEDs work by default can make a lot of sense (especially when LED1 is used in Fade In - Fade Out mode). Anyway, since the software is open source, anyone can modify it in a way that best suits their needs or preferences. Ideas and suggestions are always welcome.