[SR123]

To Continue.....

The rest of the components have now arrived, even the UV sensor from China only took a week

I have finished the Transmitter and tested it - all OK

I am now turning my attention to the sensors, for the outside Temp/Humidity I am using an SHT21. I have machined a holder for it out of some polypropylene sheet and covered it in an old fuel filter out of a petrol tank from a generator. This will go inside a home made radiation shield I made a few years ago.
   
   

For the UV/Solar sensors I have machined a housing out of polypropylene sheet, this is mounted on some 20mm conduit and will be attached to a post. I will cover the sensors with a piece of 3mm Perspex.
   
   

Thanks,