[Wim-T]

The touch screen calibration settings coded in the software, usually work for everyone, however different power supply's may require a fine tuning.
Included on the 4Pro RX software package there is an utility called 4ProDB_Touch_Calibrate_3.2TFT.ino, you can run it and past the calibration data (visible on the serial monitor), to WeatherDuino_4PESP32_RX_v6.1_b001.ino, around line 633 (uncomment the unused ones).
Software don't react to touches with an interval less than 600ms. Try give time for the screen to fully redraw before a second touch.

Wim-T Wrote:
I found the Calibrate TFT.ino file and mentioned lines to uncomment, but please give me a few more steps to go on with it.
What to do with the Calibrate TFT.ino file?

 

You are right. The name for graphics should be "Binnen Vocht"
If you would like to contribute improving the Dutch language file, your help will be welcome.

 Wim-T Wrote:
I am already working on a correction in the Dutch language file, if the file is tested i send it to you, to give it a try.

The System Temp comes from the TMP36 sensor installed on the TX board.

Wim-T Wrote:
Okay, i ordered a TMP36.

 

5) How can i change display W.dir it is always --- ? (see pict. W.Dir only ---)
Going to the webpage 192.168.1.xxx/weather, the wind direction is correct. (see pict. webpage W.Dir correct)

On many weather stations, when the wind gust is zero, the Wind Dir. is shown as Calm (with no wind there isn't instant wind direction), we use the three dashes. Once wind gust will not be zero the correct wind direction will be shown, as happen on the web page.

Wim-T Wrote:
Okay i understand.

I tryed to reply on your answers from 30-12-21, but the insert did not work for me (think i did something wrong  ), hope you can correct this thread.

Kind regards,
Wim