[Wim-T]

Hi Wim-T,


I'm glad to know that you already received your 4Pro system.

I will try to reply to your questions one by one.
 

1) Compiling the software with my configuration/setting did not work.

Start compiling gives:
Arduino:1.8.16 (Windows 10), Board:"MH ET LIVE ESP32MiniKit, 80MHz, Default with spiffs, 921600, None"
a long list started wich i have deleted, following with.
C:\Users\tijha\Documenten\Arduino\libraries\ArduinoJson/src/ArduinoJson/Array/ArrayRef.hpp:7:48: fatal error: ArduinoJson/Array/ArrayFunctions.hpp: No such file or directory
compilation terminated.
a long list started wich i have deleted, following with.
Bibliotheek DataFlash_AC in map: C:\Users\tijha\Documenten\Arduino\libraries\DataFlash_AC (legacy) wordt gebruikt
Bibliotheek ArduinoJson in map: C:\Users\tijha\Documenten\Arduino\libraries\ArduinoJson (legacy) wordt gebruikt
exit status 1
Fault compiling for board MH ET LIVE ESP32MiniKit

Solved the issue "ArrayFunctions.hpp" with latest ArduinoJson driver by Benoit Blanchon Version 6.18.5, compiling and uploading (for me) works now 100%. 

 Unless Arduino 1.8.16 introduced any change, I'm pretty sure that the software compiles fine with the provided ArduinoJson library, which is version 6.17.2.
 

2) I tryed the Dutch and English setup for menu settings, both same weird reactions.
2a. for example going from menu to weather to tab w.gust or w.speed or w.dir etc. gives different actions sometimes going back to menu.
2b. for example start in menu touch inside-temp (right-side display) or outside-temp (right-side display) gives different actions or back to menu.
2c. sometimes (maybe touching to fast) gives no longer direct action from touch screen, software seems to hang for some time. 

The touch screen calibration settings coded in the software, usually work for everyone, however different power supply's may require a fine tuning.
Included on the 4Pro RX software package there is an utility called 4ProDB_Touch_Calibrate_3.2TFT.ino, you can run it and past the calibration data (visible on the serial monitor), to WeatherDuino_4PESP32_RX_v6.1_b001.ino, around line 633 (uncomment the unused ones).
Software don't react to touches with an interval less than 600ms. Try give time for the screen to fully redraw before a second touch.


 

3) Dutch translations in grafics "Binnen Temperatuur (inside-temp)" is wrong. (see pict. Inside Temp wrong)
Gives horizontal time, vertical humidity !
Think the name for grafics should be "Binnen Vocht" (inside humidity).

You are right. The name for graphics should be "Binnen Vocht"
If you would like to contribute improving the Dutch language file, your help will be welcome.


 

4) How can i change System Temp -50 dgr ? (see pict. System Temp -50)
Is this temp coming from inside 4Pro receiver?

The System Temp comes from the TMP36 sensor installed on the TX board.



 

5) How can i change display W.dir it is always --- ? (see pict. W.Dir only ---)
Going to the webpage 192.168.1.xxx/weather, the wind direction is correct. (see pict. webpage W.Dir correct)

On many weather stations, when the wind gust is zero, the Wind Dir. is shown as Calm (with no wind there isn't instant wind direction), we use the three dashes. Once wind gust will not be zero the correct wind direction will be shown, as happen on the web page.