02-09-2021, 00:41
Hello Werk_AG,
I have already understood your suggestion, but you did not express yourself in an incomprehensible manner. :-)
The two holes marked with the circle were too far out on my first design and therefore couldn't be used, so I moved them to the correct position.
Since I don't have a model of the 4Pro and my electronic measuring teacher from China is imprecise, I designed and then "printed" it. The material consumption is quite high and I therefore decided to reposition the holes on one side only.
I got a mechanical and accurate caliper from my dad and I'm going to redesign the other side.
Greetings André
I have already understood your suggestion, but you did not express yourself in an incomprehensible manner. :-)
The two holes marked with the circle were too far out on my first design and therefore couldn't be used, so I moved them to the correct position.
Since I don't have a model of the 4Pro and my electronic measuring teacher from China is imprecise, I designed and then "printed" it. The material consumption is quite high and I therefore decided to reposition the holes on one side only.
I got a mechanical and accurate caliper from my dad and I'm going to redesign the other side.
Greetings André