28-08-2021, 12:28
(This post was last modified: 30-08-2021, 16:15 by Sun_Dancer.)
Hello weather frogs,
today I would like to introduce you to my housing for the 4Pro receiver. It's a simple, no-frills case. A wall bracket is currently in the works.
Depending on the setup, I have provided 2 recesses for the power supply, one on the side and one below.
Since I don't have a dummy of the 4Pro this time and my China slide gauge doesn't have the accuracy, the right mounting holes for the circuit board are (still) a bit too far out. However, this is not a problem if the 4Pro has the 433Mhz module, because I designed the cover in such a way that it presses against the 433Mhz module and thus the circuit board is firmly seated.
You can find the case on my Thingiverse profile: https://www.thingiverse.com/thing:4945252
if you like my designs, please be so kind and leave a like. thanks!
Greetings, André
today I would like to introduce you to my housing for the 4Pro receiver. It's a simple, no-frills case. A wall bracket is currently in the works.
Depending on the setup, I have provided 2 recesses for the power supply, one on the side and one below.
Since I don't have a dummy of the 4Pro this time and my China slide gauge doesn't have the accuracy, the right mounting holes for the circuit board are (still) a bit too far out. However, this is not a problem if the 4Pro has the 433Mhz module, because I designed the cover in such a way that it presses against the 433Mhz module and thus the circuit board is firmly seated.
You can find the case on my Thingiverse profile: https://www.thingiverse.com/thing:4945252
if you like my designs, please be so kind and leave a like. thanks!
Greetings, André