04-08-2021, 23:03
Hi Jochen,
I'm using exactly the same set of sensors, so I can assure they all work together.
Can you post your Config_Options.h file?
Pay attention to the length of the cables used with the BME280 (preferably connect it directly to the PCB) and with the SCD30. Cables must be quite short.
Also check your power supply. While the average consumption is 150mA, when reading sensors, the consumption may exceed 300mA, not all USB ports can deliver such current.
Rgs
I'm using exactly the same set of sensors, so I can assure they all work together.
Can you post your Config_Options.h file?
Pay attention to the length of the cables used with the BME280 (preferably connect it directly to the PCB) and with the SCD30. Cables must be quite short.
Also check your power supply. While the average consumption is 150mA, when reading sensors, the consumption may exceed 300mA, not all USB ports can deliver such current.
Rgs